Spectrum-controls 1734sc-IE2CH Bedienungsanleitung PDF herunterladen (Seite 23)

User’s Manual Pub. 0300257-01 Rev. A

Chapter 3

Configuring the 1734sc-IExCH

Using RSLogix 5000

This chapter covers the following subjects:

• Introduction

• About Communications

• Use Generic Profile

• Use AOP (Add On Profile)

• Module configuration

• Reading input data

• Module update time

Section 3.1

Introduction

The 1734sc-IE2CH and IE4CH allow, in addition to reading the 4 to 20 mA analog

signal, the ability to read and write HART data to and from HART compatible devices.

This chapter will describe how to configure the IExCH module using RSLogix 5000

programming software.

Section 3.2

About

Communications

The module produces and consumes data as follows:

IE2CH Produce/Consume Data

Input Assembly Options I/O Connection Type Consumes Produces

Analog + HART 0, 1 Change-of-State 0 Bytes 60 Bytes

IE4CH Produce/Consume Data

Input Assembly Options I/O Connection Type Consumes Produces

Analog + HART 0, 1, 2, 3 Change-of-State 0 Bytes 112 Bytes

Attention

The IExCH module is not compatible with the 1734-ADN, ADN(X), and

PDN device net adapters and the 1734-APB profibus adapter.

Attention

It is not recommended to update module firmware if the module is

installed behind a Control Net adapter (1734-ACNR). Only update

firmware when the module is installed behind an Ethernet adapter

(1734-AENT or 1734-AENTR).

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 83 84

Keine Kommentare

Spectrum-controls 1734sc-IE2CH Bedienungsanleitung Seite 23